Mold remediation referrals for Denver & nearby townsCall: (720) 818-9506
(720) 818-9506

Mold in Walls in Littleton, CO

moldremediationdenverco.net

A wall can hold moisture for months after a small leak, and an independent company near Littleton will find the wet spot before anyone cuts into drywall.

Musty corner you cannot explain in Littleton?
Call now to be connected with a local mold remediation company in Littleton.
(720) 818-9506

Porous materials such as drywall and insulation that stay moldy usually have to be removed rather than cleaned. A company marks the wet boundary, cuts back to clean material and dries the framing. Call the number on this page to be connected with a local mold company in Littleton.

Bubbling paint and stains on an interior wall, mold in walls in Littleton, CO

Press, sniff, look

Press gently on the lower wall. If it gives like cardboard, moisture is likely behind it. Sniff inside a closet or behind furniture along that wall. Then check the other side of the wall for a bath, sink, window or exterior stain that matches. Compare it with a dry wall.

Brick, stucco and siding

Older Denver brick homes can pass moisture through mortar joints into interior plaster or furring, and stucco with cracked sealant lets storm water in. Wood and fiber-cement siding can fail at corners and penetrations, so water slips behind the weather barrier unseen. Both can look sound.

Call now to be connected with a local mold remediation company in Littleton.
(720) 818-9506
Inspection hole cut into drywall revealing mold inside the wall, mold in walls in Littleton, CO

Remediation versus repair

Removing the mold is one job and rebuilding is another. Some companies handle both, others stop at cleaned framing and leave the drywall and paint to a contractor. Knowing where the line falls lets you compare two quotes fairly. Many homeowners hire a general contractor for the second part.

Permits, rentals and contractor checks in Littleton

Because the state doesn't certify mold remediation as its own trade, the useful checks are local: whether the company holds the contractor license your city requires, and whether it puts the scope in writing.

The Littleton Building Division handles building permits here, so that's the place to check before walls, cabinets or flooring go back in.

Tenants should report mold to the landlord in writing first; Colorado law treats mold associated with dampness as a habitability issue, with set response times after notice.

Nearby, the same kind of help is available in Englewood, Lone Tree and Louviers.

The removal itself

The crew seals the room with plastic, runs air filtration, cuts out drywall past the visible edge of growth, bags it, then cleans framing with HEPA vacuums and wipes. Insulation in that bay usually goes too. Exposed studs are dried before anything is closed up. Ask to see them.

Before buying or renovating

Opening a wall during remodeling often turns up old water damage no one knew about. If a house you are buying has repaired stains, ask about the cause and the repair. A moisture scan before closing costs far less than discovering a moldy cavity later. Do it first.

Around Littleton

Calls come in from across Littleton, including around US-85 (South Santa Fe Drive), SH-75 (South Platte Canyon Road), SH-88 (East Belleview Avenue).

Littleton says flooding there usually comes from intense spring or summer thunderstorms, with the greatest threat on small tributary streams such as Little's Creek, Slaughterhouse Gulch and Lee Gulch.

Mold in Walls questions in Littleton

Do you always have to cut into the wall?
Not always. A moisture meter and thermal camera can often show whether a wall is wet. If readings stay high, a small opening lets a company see the cavity before any larger cut.
How long does it take a wall to dry?
Drying after the cut commonly takes several days with fans and dehumidifiers, depending on how wet the framing is. Meters, not the calendar, decide when it is ready to close.
Who fixes the leak, the mold company or a plumber?
Usually a plumber, roofer or window contractor. A mold company removes growth and dries the cavity. Ask the company how repairs will be coordinated and who confirms the leak is stopped.
Will a permit be needed to rebuild the wall?
Plain drywall and paint usually are not permitted work, but replumbing, structural changes or electrical moves can be. Ask the contractor about Littleton Building Division.

More mold services in Littleton

Mold in Walls nearby

Call now to be connected with a local mold remediation company in Littleton.
(720) 818-9506

Last updated:

☎ Call (720) 818-9506