Roof leaks and ice dams send meltwater into attic insulation and ceilings, and the damp material can grow mold after the snow is gone. Call the number on this page to be connected with a local mold company in Commerce City.

What to Photograph
Capture the source, the damaged materials, a wide shot of each room and any moisture readings taken. Dated photos help with insurance conversations and with renters' disputes, and they show a mold company the original extent of the damage before anything is torn out or thrown away.
Bathroom and Kitchen Plumbing
Supply stops, drain traps, tub overflows and failed shower pans leak slowly behind tile and cabinets. A damp cabinet floor or a soft spot at the tub edge is typical. Bathroom fans that vent into an attic add moisture above, which can show as ceiling stains and peeling paint.

Useful local contacts for Commerce City
Colorado leaves contractor licensing to cities and counties and has no mold-specific license. Ask the company up front which local license covers any drywall or framing it replaces.
If the job grows into replacing drywall, cabinets or framing, ask whether the rebuild needs a permit from the Commerce City Building Safety Division.
Tenants should report mold to the landlord in writing first; Colorado law treats mold associated with dampness as a habitability issue, with set response times after notice.
Companies that take calls here usually also work in Henderson, Brighton and Dupont.
Cost Drivers at a Glance
| Driver | Effect |
|---|---|
| Time wet | Longer means more removal |
| Rooms affected | More containment and drying |
| Finishes | Hardwood and carpet add labor |
Each driver changes the scope on its own, and most real jobs involve all three at once, so an on-site look matters more than any rule of thumb or a phone guess.
Typical Sequence
- Stop the water at the source.
- Extract standing water.
- Remove materials that cannot be saved.
- Contain and clean any mold.
- Dry the structure with fans and dehumidifiers.
- Confirm readings, then rebuild.
The order varies by job, but stopping the water and confirming dry readings should appear in every written plan you are shown, whatever the company.
The 24 to 48 Hour Window
EPA advises drying wet materials within about 24 to 48 hours. Open doors and windows if the weather allows, run fans, lift furniture off wet carpet and call for extraction. Every extra day raises the chance that drywall and insulation must come out and be replaced.
Burst Pipe & Leak Mold Removal questions in Commerce City
How soon does mold start after a leak?
Will insurance cover mold after a leak?
Does a roof leak or ice dam cause mold?
Can an old washer hose cause mold?
More mold services in Commerce City
Burst Pipe & Leak Mold Removal nearby
Helpful guides
Sources
Last updated: