Blocked soffit vents choke the airflow that keeps a roof deck dry. Insulation pushed into the eaves or paint over the vent screen are frequent causes. A company clears the airflow path and treats the wood. Call the number on this page to be connected with a local mold company in Black Hawk.

After a heavy snow
Look at the roof from outside once the weather clears. Long icicles, bare patches over warm rooms, and ice built up along the eaves show where heat is escaping or where melt may find its way inside. Those are the same places to check from the attic.
Blocked soffit vents
Roofs breathe in at the eaves and out at the ridge. When insulation covers the soffit openings, or paint has clogged a screen, the stream stops. Stagnant, damp air then lingers above the insulation and keeps the sheathing wet for weeks in cold weather. Check it yearly.
Mountain houses often sit empty for stretches, and without heat on the roof deck, frost and meltwater build up in hidden spaces that nobody inspects until spring.

Insulation choice
Loose-fill, batts and spray foam each respond differently to moisture. Removing blown cellulose or fiberglass is a big part of many jobs, and spray foam is handled differently. Ask the company what type you have, and what will replace it afterward. Each one can wet attic wood and insulation.
Permits, rentals and contractor checks in Black Hawk
There is no Colorado mold license to look up. Cities run their own contractor licensing (Denver, for example, issues its own and doesn't accept other jurisdictions' licenses), so ask which one applies to your address.
Rebuild work after the mold comes out, such as new drywall or framing, may need a permit; the City of Black Hawk Building Division is the office for Black Hawk addresses.
Tenants should report mold to the landlord in writing first; Colorado law treats mold associated with dampness as a habitability issue, with set response times after notice.
Companies that take calls here usually also work in Arvada, Central City and Idaho Springs.
Containment and safety
Work crews typically seal the hatch, run air scrubbers, wear respirators and suits, and carry out debris in bags. The goal is to keep spores out of the rooms below. Expect the hatch area to be covered and the process to take a few days. Ask which one.
Before the winter
In autumn, have the roof, flashing and vent boots checked, confirm the bath fans run and duct outside, and clear the eaves. EPA suggests keeping indoor humidity below about 60 percent, ideally 30 to 50, so a humidifier setting deserves a second look. Ask about timing too.
Attic Mold Removal questions in Black Hawk
My bath fan vents into the attic. Is that a problem?
Do soffit vents really matter?
Is it safe to go in the attic myself?
Do mountain homes have more attic frost?
More mold services in Black Hawk
Attic Mold Removal nearby
Helpful guides
Sources
Last updated: